查看:
12926
回复: 9 |
请教立创EDA自动布线一直卡在57%,终端一直打印错误
|
fogwizard
5
主题
9
回复 |
发表于2019-03-10 16:18:09
|
显示全部楼层
1#
电梯直达
详细描述如下: 1.板子两层,图纸是从altium的asc文件导入。自动布线时,一直卡在57%,换了3台电脑,表现一致。 2.试画一块简单的板子,自动布线可以成功布完,并且在立创pcb打样回板后,板子可以用。 是否跟板子的复杂度有关? 还是我这边哪里没有设置好? 谢谢 终端一直打印错误: Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is nullSimplex.calc_division_lines: division not found Simplex.cutout_from: division line is null Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is null Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is null Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is null Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is null Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is null Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is null Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is null Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is null Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is null Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is null |
Binglee
4
主题
10
回复 |
发表于2021-03-06 01:00:54
|
显示全部楼层
10#
只要是做PCB的软件,自动布线就是个鸡肋,简单点的还行(其实还是要修改的),复杂点的后面工作量比手动重新画还多
|
|