查看:
12931
回复: 9 |
请教立创EDA自动布线一直卡在57%,终端一直打印错误
|
|||
fogwizard
5
主题
9
回复 |
发表于2019-03-10 16:18:09
|
显示全部楼层
1#
电梯直达
详细描述如下: 1.板子两层,图纸是从altium的asc文件导入。自动布线时,一直卡在57%,换了3台电脑,表现一致。 2.试画一块简单的板子,自动布线可以成功布完,并且在立创pcb打样回板后,板子可以用。 是否跟板子的复杂度有关? 还是我这边哪里没有设置好? 谢谢 终端一直打印错误: Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is nullSimplex.calc_division_lines: division not found Simplex.cutout_from: division line is null Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is null Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is null Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is null Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is null Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is null Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is null Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is null Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is null Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is null Simplex.calc_division_lines: division not found Simplex.cutout_from: division line is null |
|||
47okey
4
主题
27
回复 |
发表于2021-02-19 12:45:03
|
显示全部楼层
8#
这招很灵!昨晚也是自动布线一直在0%不动,看了你的这,选黄色顶层丝印试了,瞬间100%,太感谢了。
|
|